We have begun work on this contemporary low energy house on a garden plot in Bristol, designed by Emmett Russell Architects.

On this occasion, we are acting as principal contractor and working with architect, engineer and energy consultant to ensure the final product meets the design criteria in every way.

The house will have a super insulated timber frame structure sitting on a conventional concrete raft/trench fill foundation.  Walls will be finished with a combination of local rubble pennant stone on the ground floor and render above, with the roof finished in traditional standing seam Zinc.

Typical of houses that we have built in the last few years this house has not only been designed to near Passivhaus standards, but also uses natural (non petrochemical) products wherever practicable and is looking to the future for its energy supply and ways of living.

Features include:

• Very little space heating required
 - cheap to run 
-  very comfortable
• U values below 0.13
• Airtightness of less than 1 acph
• Minimal cold bridging
• High quality MVHR unit with rigid Lindab ducting
• Careful consideration to maximizing solar gain and eliminating solar overheating
• Photo voltaic panels with potential for battery add on later
• Air Source Heat Pump (ASHP) instead of a gas boiler providing hot water and heating
• Electric car charging point provision 

The house is scheduled for a January 2020 finish - keep an eye on our website and Instagram for site updates

It's all kicking off in Colerne!  Groundworks have begun on a three-bedroom, timber-clad home in rural Wiltshire, that will be built to Passive House standard.

​Our experienced team have already started the complex groundworks - which involve ground retaining walls and underpinning existing structures - on the steep, tight site, which is the clients' current garden.  The clients can look forward to moving into their new Passivhaus-standard home in around twelve months time, enjoying spacious open-plan living with bedrooms downstairs and living quarters upstairs, to maximise enjoyment of the views down the valley.  

​The house will have a car-charging port, Thin Film PV Panels applied to the metal standing Seam roof and an air source heat pump providing heating and hot water. The finishes will be Larch, Breathable Render and Cotswold Stone. 

Lots of hard work ahead on this exciting eco home that has been thoughtfully designed by CaSA Architects and Greenheart.

See above for how it WILL look... and below for how it looks at this early stage!

We have set to work on the refurbishment and extension of a tired 1950's two-storey house in Backwell, near Bristol, designed in collaboration with s2 design.

A large two-storey, open plan Timber frame extension will have lots of glass to the rear of the building to make the most of the views over the Severn estuary, with WARMCEL insulation and high spec triple glazed windows keeping it snug.

The existing house will be fully refurbished with new windows, improved levels of insulation and new interior layout.